Rogue-engineering Rhino-10 User Manual download pdf

Charging Ahead

Rogue Engineering Inc.

3860 S. Jason Street

Englewood Colorado 80110

1-800-364-0659 (Toll Free) 1-303-734-0706 (Phone)

1-303-734-0517 (Fax) www.rogue-engr.com

info@rogue-engr.com or sales@rogue-engr.com

Rhino- 10, 12/24 Volt - 10A SLA with

Low Voltage Disconnect and Reset

Capability

SOLAR BATTERY CHARGE

CONTROLLER

Part No. 1950-162

Doc. Rev 120831

Designed and Manufactured by

Rogue Engineering Inc.

in Englewood, Colorado, U.S.A.

The graph above shows a charging cycle typically found when an SLA battery has

discharged overnight. The red line (upper) indicates the battery terminal voltage

and the green line (lower) indicates the charging current supplied to the battery.

With the battery below 2.13 Volts per cell, the charge controller enters

the bulk charge mode. The charger will supply the maximum current

possible to the battery until the terminal voltage reaches 2.45 Volts per

cell. As the battery approaches a fully charged state, the charger enters a

compensation charging mode and the charging current will taper o. When

the current reaches a steady-state value, the controller will switch to the

oat charge mode. The controller will both supply current to the load and

maintain the battery at 2.35 Volts as long as charging power is available.

1 2

Charging AheadRogue Engineering Inc. 3860 S. Jason Street Englewood Colorado 801101-800-364-0659 (Toll Free) 1-303-734-0706 (Phone) 1-303-734-0517 (F

Page 2

Charging AheadRogue Engineering Inc. 3860 S. Jason Street Englewood Colorado 801101-800-364-0659 (Toll Free) 1-303-734-0706 (Phone) 1-303-734-0517 (F

No comments

Rogue-engineering Rhino-10 User Manual